8 Pilot devices M22-SWD…8.3 M22-SWD base fixing198 SmartWire-DT modules IP20 09/17 MN05006001Z EN www.eaton.com8.3.6 Device statusThe individual SWD modules indicate their device status with the aid of adiagnosis LED.Table 47: Diagnostic messages of the SmartWire-DT status LED8.3.7 Parameter definitionDepending on the coordinator being used, the module's parameters willneed to be configured in the programming system or in the SWD-Assist plan-ning and commissioning program.8.3.8 Fieldbus-specific characteristicsField bus EthercatPlease note the general information for configuring parameters￫ Chapter 13 “Using SWD modules with the EtherCAT field bus”, page247.8.3.9 ProgrammingThe various function elements have specific input/output information that isprocessed in the programming system. The meaning and scope aredescribed in the following.8.3.9.1 M22-SWD-KC11The function element has one input byte at its disposal.InputsByte 0:Designation Color Status MessageSmartWire-DT Green Continuous light Device is operating fault-free.flashing (1 Hz) • addressing process in progress• after gateway power On• after actuation of the configurationbutton on the gateway• Module not in current configuration• invalid typeflashing (3 Hz) Device reports a diagnosis. (￫ Section“8.3.9 Programming”, sub-point “Diagnos-tics”.)NO1NC1
