Eaton SmartWire-DT Manual

Also see for SmartWire-DT: Application Manual Manual

Contents

8 Pilot devices M22-SWD…8.2 M22-SWD front mounting178 SmartWire-DT modules IP20 09/17 MN05006001Z EN www.eaton.comOutputsNoneDiagnosticsIn the event of a diagnosis the module reports the following error causes (0is set for bit 4 in the input byte):8.2.9.3 M22-SWD-LED-(W/B/G/R)The function element has one input byte and one output byte at its disposalInputsByte 0:Bit Designation Meaning0 NC1 = Normally Closed 0: contact 1 actuated1: contact 1 not actuated1 NO1 = Normally Open 0: contact 1 not actuated1: contact 1 actuated2 NC2 = Normally Closed 0: contact 2 actuated1: contact 2 not actuated3 NO2 = Normally Open 0: contact 2 not actuated1: contact 2 actuated4 DIAG 0: no diagnostic alarm1: Diagnosis present5 Not used –6 PRSNT 0: Module not available1: Module available7 SUBST 0: Configured module present1: Universal module M22-SWD-NOP(C) presentValue Meaning0x10 The contact is in the middle position for longer than fourseconds.0x11 Contact short-circuit7 6 5 4 3 2 1 0SUBST PRSNT – DIAG – – – –