2 I/O modules EU5E-SWD…2.12 Analog module EU5E-SWD-4AXSmartWire-DT modules IP20 09/17 MN05006001Z EN www.eaton.com 472.12 Analog module EU5E-SWD-4AX2.12.1 IntroductionThe EU5E-SWD-4AX SmartWire-DT I/O module features four analog inputs.Voltage sensors (0 - 10 V) or current sensors (0 - 20 mA) can be connected tothe inputs.Finally, the SmartWire-DT diagnostic LED is used to signal the network's/module's status.2.12.2 Surface mountingFigure 20: Layout of module EU5E-SWD-4AX2.12.3 EngineeringThe analog inputs can be connected as two-wire connections. The inputs areelectrically isolated from the SmartWire-DT network but not from each other.The signal range (voltage 0–10 V, current 0–20 mA) can be separately set foreach of the four analog outputs in the programming system’s control config-urator. The resolution is 12 Bit.abcda SmartWire-DT cable with external device plugb SmartWire-DT diagnostics LEDc Inputs I0 – I3d 0-V-24-V connection supply￫ All 0 V connections (Ix- ; x = 0, 1, 2, 3) are connected with eachother and with the module’s 0 V supply.
