2 I/O modules EU5E-SWD…2.4 Programming, setting the parameters20 SmartWire-DT modules IP20 09/17 MN05006001Z EN www.eaton.comThe push-in terminals are suitable for AWG24 to AWG16 cables and cableswith a cross section from 0.25 to 1.5 mm 2 .2.4 Programming, setting the parametersFor information on programming, including the scope and structure of thecorresponding data, please refer to the relevant detailed descriptions.The SmartWire-DT I/O modules can be configured flexibly, with the availableconfiguration options depending on the specific part no. being used. The typeof parameter configuration will vary depending on the selected SmartWire-DT coordinator (gateway, PLC, etc.). For special instructions for the CANo-pen and EtherCAT protocols, please refer to the I/O module descriptions.When using these protocols, the modules need to be configured by enteringthe appropriate parameter values.Installation→ The I/O modules draw their energy for communication electron-ics, activation of the LEDs and of the I/O modules from theSmartWire-DT network supply.Please take into consideration the total power consumption ofyour SmartWire-DT network and, if necessary, plan for an addi-tional feeder module EU5CSWD-PF2-1.→ For the I/O module’s power consumption, see the table in theappendix on → Chapter 13 “Using SWD modules with theEtherCAT field bus”, page 247.→ The individual sections describe the structure behind the param-eter data and explain how to figure out what the correct param-eter data should be.For additional information, please refer to "Fieldbus-specificcharacteristics" in the "Parameter configuration" section for eachindividual module.For general information on the EtherCAT fieldbus system,please refer to → Chapter 13 “Using SWD modules with theEtherCAT field bus”, page 247.