9 SL4-SWD and SL7-SWD base modules for signal towers9.4 Installation208 SmartWire-DT modules IP20 09/17 MN05006001Z EN www.eaton.com9.4 InstallationThe SmartWire-DT base modules are designed for screw fixing. They can beplaced in any mounting position.9.4.1 MountingFor ease of wiring, leave a clearance of at least 3 cm to the wall or adjacentdevices.To mount the SmartWire-DT base module, follow the steps below:▶ At the spot where you want to mount the module, make an opening thatis large enough for the SWD ribbon cables to go through. The ribboncables have a width of 19 mm. The rapid mounting adapter's opening hasa diameter of 33 mm.▶ Drill 4 holes for the rapid mounting adapter using the mount drilling tem-plate found in installation instructions IL047002ZU.▶ Use the M5 screws to fasten the rapid mounting adapter to the equip-ment.Figure 81: Installing the rapid mounting adapter▶ Thread the ribbon cable coming from the SmartWire-DT coordinator, aswell as the ribbon cable starting from the base module, through the rapidmounting adapter's opening.▶ If necessary, connect an external auxiliary power, ￫ Section9.4.2, „Connecting the external supply voltage“, page 210.▶ Connect the SmartWire DT￫ Section 9.4.3, „Connect SmartWire-DT“,page 211.NOTICEThe specified IP66 degree of protection will only be achieved ona smooth, solid surface with the same degree of protection, andonly if a signal tower is installed.1 Nm(10 lb-in.)4 x M5
