7 Electronic motor starter EMS-…-SWD-ADP7.2 Surface mounting154 SmartWire-DT modules IP20 09/17 MN05006001Z EN www.eaton.com7.2 Surface mountingFigure 57: EMS-...-SWD-ADP electronic motor starter layouta Connection of SmartWire-DT external device plugb Sealable coverc 3-phase input voltage (1L1, 3L2, 5L3)d Diagnostics LEDe Setting dial for motor currentf Reset pushbuttong LED PWR: supply voltage, R: clockwise operation, L/ON: anticlockwise operation/motor starter ON (EMS-R.../EMS-D),ERR: faulth 3-phase output voltageThe SmartWire-DT external device plug with an installed SmartWire-DT rib-bon cable is plugged into the EMS-...-SWD-ADP electronic motor starterusing connector ①.The 8-pin SmartWire-DT ribbon cable carries not only the communication sig-nal, but also a 24 VDC U AUX voltage used to power and control the electronicmotor starter.Diagnostics LED d indicates the unit's communication status regardingcommunications with the SmartWire-DT system; ￫ Section7.7.1, „Diagnostics LED“, page 164.￫ For detailed instructions on how to connect the SmartWire-DTexternal device plug (SWD4-8SF2-5) to the 8-pin SmartWire-DTribbon cable, refer to the "Installing SWD4-8SF2-5 externaldevice plugs" section in manual MN05006002Z-EN (previouslyAWB2723-1617en).ahgfebcd
