Eaton i-on series Engineering Manual

Also see for i-on Series: Administration and User Manual Administration and User Manual Engineering guide

Contents

Installer Menu Options i-on RangePage 102OffThe remote control user cannot force set the system, even if you have applied theforce set zone attribute to any zones.ConfirmThe remote control user can force set the system. They must operate as follows: 1)the user presses the appropriate button to set the system, 2) the control unit does notstart setting, 3) the user presses the same remote control button to confirm that theywish to continue setting the system.OnThe user need only press the remote control button once to complete setting thesystem.Note: The Confirm and On options will also allow a user with a remote control to set thesystem if a reset is required after an alarm.If any user is attempting to reset the system from a wired keypad when a remoteuser tries to set the system, then the control unit will temporarily ignore the remoteuser.Tamper OmitIf a user omits a zone, it may be necessary to also omit the tamper belonging to that zone.This option allows you to do that:EnabledThe tamper is omitted when a user omits a zone.DisabledThe tamper is still operational when a user omits a zone.CSID Code (Anti-Code Reset)Anti-code reset allows an alarm company to control remotely whether a user can reset thesystem after an alarm. If the system is programmed for anti-code reset, then after an alarma user can silence the sounders. However, the display tells the user the first zone to alarm,and then instructs them to call the ARC and quote a four digit code. This four digit code iscalled the “reset code”.If the ARC decides to allow the user to reset the system then they:Key the reset code into a device or program that produces an “anti-code”.Tell the alarm system user the anti-code.The alarm system user then keys the anti-code into their keypad and the alarm systemresets.In order for this procedure to work both the alarm system control unit and the ARC musthave the same “CSID” code. This acts as a seed for computing both the reset code and itsanti-code. The ARC usually generates the CSID code.Use this option to program the control unit with the CSID required for anti-code reset. Ifyou set the CSID to “0000” then the control unit will not use anti-code reset. If you sent theCSID to any number 0001 to 9999 then the control unit will use anti-code reset.Silence AlertsThis option controls the length of time that the keypad gives the alert tone (a brief ‘beep’every few minutes) when there is an alert. The options are:UserThe keypad gives the tone until a user keys in their access code to acknowledge thealert.