Eaton i-on series Engineering Manual

Also see for i-on Series: Administration and User Manual Administration and User Manual Engineering guide

Contents

i-on Range The Installer MenuPage 41MENU Option Factory Default NotesTechnical Alarm: NoMasking: YesTampers: YesSet/Unset: Yes (see Note 2)Part Set: Yes(see Note 2)Reset: Yes (see Note 2)Exit timeout: YesOmit: YesRF Supervision: YesRF Jamming: Yes (see Note 2)RF Battery/PSU: Yes (see Note 2)Panel Battery: Yes (see Note 2)Mains Fail: Yes (see Note 2)Faults: Yes (see Note 2)Installer Mode: Yes (see Note 2)User Code Changed: YesTime/Date Reset: NoDownloading: No2. This setting is required in orderto comply with EN50131.Downloading and masking eventsnot available on i-on16.Restorals EnabledBurg Comms Rearm Enabled Appears only when ReportType=Fast Format AND whenConfirmation Mode = “Basic”21CN FF Ack time 800ms Appears only when ReportType=Fast Format.Send tamper as burg Disabled Appears when Report Type=CIDor SIA.Dynamic Test Call Enabled Appears only when StaticTest CalldisabledStatic Test Call Disabled Appears only when Dynamic TestCall disabled.To comply with EN50131, eitherStatic or Dynamic test calls mustbe enabled. This is available onlywhen an i-sd02 is fitted and ARCCommunications enabled.Unset Comms EnabledSpeech Dialler Only visible when suitablecommunications module fitted.Call Mode DisabledMessages NonePhone Book EmptyTriggers NoneDestinations NoneCall Acknowledge EnabledSMS Only visible on i-on30EXD and i-on50EXD or when suitablecommunications module fitted..Call Mode DisabledMessages BlankPhone Book EmptyTriggers NonePSTN SMSProtocol ETSI Protocol 1 (i-on40 and i-onEX range)TAP-8N1 (i-on16 only)Service Centre Tel 1470,17094009 (i-on40 and i-onEX range)07785499993 (i-on16 only)BTOwn Telephone No. Empty Appears only protocol=UCPLine Fail Response Audible Only visible on i-on30EXD, i-on50EXD or when suitablecommunications module fitted..Line Fail Delay 9s This setting is required in order tocomply with EN50131.