i-on RangePage 33Installer MenuImportant: Where noted below the defaults listed enable the control unit to comply withEN50131 requirements. If you change those settings then the installation may no longercomply. If the control unit does not comply with EN50131 you must remove any labellingthat indicates compliance.MENU Option Factory Default Notes1 DETECTORS/ DEVICESDetectorsAdd/Del DetectorsExp. R1-nn 30 50 160First radio expander with sparezonesAppears only if a radio expander isavailable on the bus.Zone number depends onexpander number.Zone nnn...Delete all Deletes all radio zones on theselected expander.Program ZonesZone 000...159(see note)Actual number of zones dependson panel type and expandersfitted.Name “Zone nnn”Type Not usedPartitions None 30 40 50 160Appears only in a Partitionedsystem and when zones have atype other than “Not Used”.Attributes Chime: NoSoak Test: NoDouble Knock: No (not i-on16)Part Set B: NoPart Set C: No (level setting system only)Part Set D: No (level setting system only)Part Set: No (partition system only, not on i-on16)Omittable: NoForce Set Omit: NoMasking: No (not i-on16)Inverted: No (not i-on16)Shock NoRoller Shutter: No (see notes)Reset: NoAppears when zone is given a typeother than “Not Used”.Some attributes are only availableon particular zone types.Double Knock does not complywith EN51031.Masking must be enabled inSystem Options.(Roller Shutter is available only oni-on160EXEUR.)Address Bus Device 30 50 160Wired Expanders 30 50 160Address Bus DeviceEdit ExpanderExpander W1-01...W1-45 Display shows expanders currentlyaddressed on bus. Max numberdepends on control unit type.Name “Exp. W1-nn” nn is between 01 and 45,depending on control unit type.Partitions Partition 1. Appears only in a partitionedsystem.Wired zone type FSL 2k2/4k7Loudspeaker volume Zero when expander first added to bus. (Alarm and tamper tones alwaysbe emitted at 100%.)Battery 2 Disabled Appears only for EXP-PSU