Installer Menu Options i-on RangePage 64Disabled The control unit stops transmitting data to all the Info ModulesEnabled The control unit carries on transmitting to the Info Module.The default setting for this menu option is Disabled. The control unit changes the setting toEnabled when you teach an Info Module the control unit’s identity.Enabling the Ready to Set LEDThe Info Module possesses a LED that glows when the alarm system is NOT ready to set(for example, because a detector is reporting an alarm). To disable or enable this LEDselect Detectors/Devices – Info Module - Ready-to-Set LED. The available options are:Enabled The control unit carries on using the Ready to Set LED on the Info Module.Disabled The control unit stops using the Ready to Set LED the Info Module.WAMs30 40 50 160Each control unit in the i-onEX range can learn the maximum number given on page 9.Although the WAM provides five different modes, when working with an i-onEX rangecontrol unit only mode 1, repeater module, is relevant. The installer must select therepeater mode when commissioning the WAM hardware.Note: i-on40 Release 4 uses WAMs as repeaters only.When working as a repeater module the WAM repeats the signals from any detectorswithin its range, amplifying them to a level that the control unit can detect. This allows youto increase the area covered by radio detectors.Naming WAMsUse the Edit WAM option to give each WAM a meaningful name. The name can be up to12 characters long.OutputsThe control unit provides three different sets of outputs:Dedicated Bell and Strobe outputs.Plug-by outputs.Hardwired outputs.(See the relevant Installation Guide for the position of connectors.)See “System Capacities” on page 9 for a list of the number of outputs provided directly byeach control unit pcb.30 50 160 In addition to the outputs wired directly into the control unit, expandersalso provide outputs:Each wired expander provides 4 outputs on its PCB.Radio expanders each provide 8 radio output channels.When fitted to any of the i-on control units a KEY-KPZ01 keypad also provides a singlewired outputThe hardwired outputs on the control unit, expanders (together with the radio outputs onthe expanders) and KEY-KPZ01 can be programmed as any of the output types listed onpage 66.