Eaton i-on series Engineering Manual

Also see for i-on Series: Administration and User Manual Administration and User Manual Engineering guide

Contents

i-on Range Installer Menu OptionsPage 73Type:(nn=shortcut) Active when:Assign toPartitions?Pulsed?Burg Confirm timer(50)(Not available on –EUR versions. Operates onlywhen DD243 or BS8243 is enabled.) Burgconfirmation timer is running. Inactive when thetimer stops.No YesHUA confirm timer(51)(Not available on -EUR versions. Operates onlywhen BS8243 is enabled.) HUA confirmation timer isrunning. Inactive when the timer stops.No YesRearmed (52) In a part setting system the control unit activates theoutput if the system re-arms at least once after theuser armed it. If Confirmation Mode is set to DD243or BS8243 then the control unit activates the outputas it rearms the system after the confirmation timerexpires. If Confirmation Mode is set to Basic thenthe control unit activates the output as it rearms thesystem when the bell/siren time expires.In a partitioned system you can allocate the outputto individual partitions.The control unit deactivates the output when a useror installer resets the system/partition.Yes YesBurg ConfirmedAlarm (53)(Not available on –EUR versions. Operates onlywhen BS8243 is enabled.) A confirmed Burg(Normal Alarm) has occurred. The control unitactivates this output when:a) Two separate Normal Alarm (Burgs) haveactivated in the same partition within theconfirmation time.b) A Normal Alarm and Tamper are active (in anyorder) from the same partition within theconfirmation time.You can assign this output to one or more partitions.Note that the Normal Alarms (and tampers) mustboth be in the same partitions as the output. Thecontrol unit deactivates the output when a user orengineer resets the system.Yes YesPrograming Zone Follow OutputsOutput type 39 allows you to program Zone Follow outputs.The control unit activates a Zone Follow output when a selected zone is active. The controlunit can activate the output whether the zone is set or unset.In the Installer Menu, while programming a Zone Follow output type, the control unit givesyou the following options:PolarityPolarity can be either Normal or Inverted. When programmed as Normal the output is