Eaton i-on series Engineering Manual

Also see for i-on Series: Administration and User Manual Administration and User Manual Engineering guide

Contents

Installer Menu Options i-on RangePage 13430 50 160If the alarm system has an EXP-PSU connected then this menu also lets you check thecurrent used by the EXP-PSU itself.Battery(s)50 160This option allows you to carry out a load test on any standby batteries connected to thecontrol unit, or of batteries in any EXP-PSU connected to the system. From the Installermenu select Test – Battery(s). The bottom line of the keypad display shows the first in alist of all devices with standby batteries connected (which is the control unit).Press  or  to scroll up or down the list of devices.Press  to start load testing the batteries connected to the device.The keypad display shows the message “Please wait...” while the device carries out theload test. After several seconds the bottom line of the display shows either “Pass” if thebattery has passed the test, or “Fail” if the battery failed the test.Press  before starting another battery load test.When there are two batteries connected in either control unit or EXP-PSU the control unittests each battery on its own, waiting in between tests for the test load to cool down. At theend of both tests the keypad display shows the results for both batteries on the bottomline.Locate Panel50This Test menu option allows you to start and stop a tone from the piezo buzzer fitted tothe i-on50EX/EXD control unit pcbs. This feature is provided to help you locate the panelin a system with which you are not familiar.Press  to turn on the control unit’s buzzer. (Press  or  to turn it off again.)Locate Bus Device30 50 160The Test menu allows you to list all the devices connected to the bus, and to find outwhere they are located by activating their internal sounders. From the Installer menu selectTest – Locate Bus Device.The control unit presents the first item in a list of all the devices connected to the bus. Thekeypad display shows the expander bus number, and any name that has beenprogrammed for it.Press  or  to scroll up or down the list.Press  to turn on the device’s buzzer. (Press  or  to turn it off again.)Using LEDs for Bus DiagnosticsYou may notice the DIAGNOSTIC LED flashing on an expander PCB. The LED gives one,two, three or four flashes a second. Each of these sequences has the following meaning.Number ofFlashesMeaningOne (normal) Communication with control unit over bus is OK