Eaton i-on series Engineering Manual

Also see for i-on Series: Administration and User Manual Administration and User Manual Engineering guide

Contents

i-on Range Installer Menu OptionsPage 121Line Fail Delay (For Plug-on or Built-in Module)This menu controls the length of time that the control unit waits until starting an alert if thecommunications line connected to either a plug-on or built-in communication module fails.The values available are 0 to 60 seconds.Note: The control unit may take a few seconds to recognise a line fail. The actual delaybetween line fail and the resulting alert will be slightly longer than the value youprogram within this option.IP Network (Own)40 50 160This menu allows you to:a) Give the control unit its own IP (Internet Protocol) address, used for the built in webbrowser interfaceb) Give any GPRS or Ethernet module their own IP numbers ready for use with IP AlarmReporting or IP Downloading.Note that an Installer cannot set an alarm system using the web browser interface. A usercan log into the web browser interface to do this.If there is no GPRS or Ethernet module present then the IP Network (Own) menu containsthe following options:Web Server This sub-menu controls the availability of the control unit’s built-inweb browser interface. There are three lower options:Status Set the Status to Enabled in order to make the web browserinterface available. Setting Status to Disabled halts the webbrowser interface.Port Number This is the port that the control unit uses for the webbrowser interface. The format is a group of digits up to five digitslong. The default port is 80.VKP Instant This option controls the availability of a standalonevirtual keypad, known as the Virtual Keypad Instant or VKP Instant.When the option is set to Enabled, VKP Instant is enabled.Provided the control unit is connect to a network through itsEthernet port and the Web Server is enabled then anyone on thenetwork can connect to the control unit through the url: “http://[panelIP:Port Number]/keypad.cgi”.Note that if the Port Number is left at the default of “80” then the urlis “http://[panel IP]/keypad.cgi”.For example:1. If the control unit IP address is 198.162.0.100 and the portnumber is 12344 then a user can type the url “http://198.162.0.100:12344/keypad.cgi” into the address bar of theirbrowser, and the control unit will present a virtual keypad in thebrowser window.2. If the control unit IP address is 198.162.0.100 and the portnumber is 80 then a user can type the url “http://198.162.0.100/keypad.cgi” into the address bar of their browser,and the control unit will present a virtual keypad in the browserwindow.Note: The browser must have cookies enabled for VKP Instant towork correctly.