i-on Range Installer Menu OptionsPage 123Gateway Address This is the IP address of the router that connects the local network,to which the module is connected, to rest of the Internet (or to alarger network).If necessary, key in the gateway IP address. Thisnumber has the same format as the IP address.Note: If you leave IP Address, Sub-Net Mask and Gateway Addressblank then the control unit will use DHCP (Dynamic Host ControlProtocol) to obtain these values from a DHCP server.Port Number This is the port that the module uses when connecting toDownloader.Note: Once you have entered the details described above, you can see what IP addressyou have given the control unit by selecting the About Panel - About Comms - IP Addressoption from the Installer menu.GPRS Module30 40 50 160If you have fitted a GPRS module you will also see the menu option “Module: GPRS”. Thismenu has the following options:IP Address This is the module’s own IP address. If you leave it blank theservice provider will give the module an IP address using DHCP.(Eaton’s Security Business recommends that you leave this fieldblank.)Port Number If you wish to change the port number used by the module then keyin the new port number here.APN Key in the GPRS Access Point Name here.Username Use this option to store the GPRS User ID.Password Use this option to store the GPRS password.Downloading(The i-on16 does NOT support downloading.)The control unit can communicate with Downloader software running on a PC. Downloaderconnects with the control unit either locally over the USB (Universal Serial Bus) port or, ifyou have fitted an i-sd02, i-dig02 or i-gsm02 module, remotely over a telephone line. (Thei-on30EXD and i-on50EXD can use their built-in communicators for remote connections.)While connected Downloader can inspect and/or change the control unit’s programmingconfiguration. If you do not wish to change the configuration you can simply monitor thestate of the control unit and its zones from the PC.When you have finished making changes to the control unit’s programming then use theDisconnect icon in Downloader to end the connection. DO NOT remove power from thecontrol unit before disconnecting or all your changes will be lost.The alarm system user can prevent a control unit from accepting incoming calls fromDownloader. If the user sets the User Menu - System Config – Facilities On/Off – RemoteAccess option to “No” then the control unit will reject all attempts by Downloader to open aconnection. Note that this option does NOT prevent the alarm system user from starting acall to Downloader by using User Menu – System Config – Call Downloader.If you intend to use an i-gsm02 module then:For dial-in access then you must provide a SIM card that permits data traffic.A voice only SIM will allow a user to start a call to Downloader from the User Menu.