i-on RangePage 44Installer Menu OptionsThis section contains reference information for the options provided in the Installer Menu.Detectors/DevicesDetectorsAdding or Deleting Radio DetectorsAdd a Radio Detector To The SystemTo use a radio zone the control unit must learn the identity of the radio detector.When learning detectors on an i-onEX range control unit you first select a radio expanderto assign that detector to, and then learn the detector’s identity. Remember that EXP-R10expanders can learn 10 radio detectors, while EXP-R30 expanders can learn 30 detectors.(Note that the i-on30EX and i-on30EXD can only use the first 20 zones of those providedby the EXP-R30.)Deleting All Radio Detectors From The SystemIf you wish to remove all the radio detectors from the system first selectDetectors/Devices - Detectors – Add/Delete Detectors. Then:On an i-on16 or i-on40 press and you will see Delete All on the bottom line of thedisplay.On an i-onEX control unit, when the display shows the first radio expander, press and you will see Delete All on the bottom line of the display.When you delete all radio detectors the control unit sets all radio zones to Not Used, anderases the identities of all the radio transmitters that it has learned.Deleting All Zones From A Radio Expander30 50 160To delete all detectors from a single wireless expander selectDetectors/Devices - Detectors – Add/Delete Detectors from the Installer Menu. The bottomline of the display shows the first of the radio expanders. Press or to display theexpander you wish to delete detectors from. Press to select the expander. The bottomline of the display shows the first of the zones belonging to that expander. Press andyou will see Delete All on the display. Press to select the option. The display asks you toconfirm your choice. Press to finish deleting all the detectors from the expander, or ifyou wish to keep the detectors.If you press the control unit sets all zones belonging to the expander to Not Used, anddeletes the identities of all radio transmitters assigned to the expander.Deleting a Single DetectorTo delete an individual detector select Detectors/Devices - Detectors – Add/DeleteDetectors from the Installer Menu.There are two options:Delete Detector IDUse this option to make the control unit “forget” the ID of the detector, but leave anyzone programming in place.