Eaton i-on series Engineering Manual

Also see for i-on Series: Administration and User Manual Administration and User Manual Engineering guide

Contents

i-on Range Basic Programming ProceduresPage 13Once the lock out time has expired then the user can try and key in their access codeagain. If they still key an incorrect code then the system will lock all keypads for another 90seconds, but will not start another tamper alarm.An “Excess Keys Tamper” can also occur if:Any user presents an unrecognised prox tag to a keypad four times consecutively.An installer or any user enters their access code incorrectly four times in a row whileattempting to gain access to the web browser.Transferring to Another KeypadWhile in the Installer Menu, you can transfer to any other wired keypad without leaving theInstaller Menu. To do this simply go to any other wired keypad and enter the Installeraccess code. The new keypad will pick up your position in the Installer Menu. The keypadyou have left will briefly display the message “Installer session transferred” for 5 secondsbefore reverting to the time and date.To leave the Installer Menu at any time:1. Press  until the display shows: 2. Replace the control unit lid (if you removed it earlier).Ensure the control unit tamper switch is closed.3. Press  to leave Installer menu.(Press  if you do not want to leave the menu.)The display shows:The control unit scans the bus to check for any devicesthat have been added or removed without using theinstaller menu. On a large system this may takeseveral seconds.When the control unit has finished scanning the bus,the display shows the time and date. The system isready for use.Duplicated Bus DevicesIf the control unit finds that two bus devices have thesame bus address when you try to leave InstallerMenu, then it will show the duplicated addresses onthe keypad screen.You must press  to re-enter the Installer Menu, andthen go and re-address one of the duplicated devices.Missing or Extra Bus DevicesIf the control unit finds a device missing, or one with anaddress that has not been added using the InstallerMenu then the display shows, for example:The top line of the display shows the number of newdevices found, and the number of existing devicesmissing (lost). The bottom line of the display shows thefirst in the list of found and lost devices.