Eaton i-on series Engineering Manual

Also see for i-on Series: Administration and User Manual Administration and User Manual Engineering guide

Contents

Installer Menu Options i-on RangePage 74active when the zone is active. When programmed as Inverted the output is activewhen the zone is inactive.PulsedWhen Pulsed is set to “No” then the output changes state when the zone changesstate. When Pulsed is set to “Yes” the control unit provides the following options tocontrol the length of time the output is active:Delay: You can program a delay time of between 0 and 999 seconds between thezone being activated and the output becoming active. (Programming “0” secondsmeans that there is no delay.On Time: You can program the length of time that the output will remain active from1 second to 999 seconds. (0 seconds is not allowed.)ZonesThis option allows you to select which zones the output will follow. Scroll down the listusing  or . To select a zone press  or  to change “Off” at the bottom right ofthe display to “On”. The control unit will not display zones with type Not Used.Programming Zone Alarm OutputsOutput type 40 allows you to program Zone Alarm Outputs.The control unit activates a Zone Alarm output when a selected zone is active while setand capable of causing an alarm. The control unit deactivates the output when a userresets the alarm.There are restrictions to the types of zone that a Zone Alarm output can work with.1. The zone must be capable of causing an alarm. This means that Zone Alarm outputswork with the following zone types:Fire Alarm, Normal Alarm, Entry Route, Tamper, 24 Hour, Technical. A Final Exit zonewill also cause an alarm if the Enty Time runs out before the user unsets the system.2. The selected zone must be set.In a part setting system either the system must be full set, or the zone must belong tothe part set that the user has selected.In a partitioned system ALL the partitions that the zone belongs to must be set. If apartition is part set the zone must belong to the part set that the user has selected.3. Fire Alarm zones are an exception: they will cause an alarm whether the zone is set orunset.In the Installer Menu, while programming a Zone Alarm output type, the control unit givesyou the following options:PolarityPolarity can be either Normal or Inverted. When programmed as Normal the output isactive when the zone is active while set. When programmed as Inverted the output isactive when the zone is inactive while set.PulsedWhen Pulsed is programmed as “No” then the output changes state when the zonechanges state. When Pulsed is set to “Yes” the control unit provides the followingoptions to control the length of time the output is active:Delay: You can program a delay time of between 0 and 999 seconds between thezone being activated and the output becoming active. (Programming “0” secondsmeans that there is no delay.On Time: You can program the length of time that the output will remain active from1 second to 999 seconds. (0 seconds is not allowed.)