Eaton i-on series Engineering Manual

Also see for i-on Series: Administration and User Manual Administration and User Manual Engineering guide

Contents

Installer Menu Options i-on RangePage 50One partition only Any partition01 HUA 03 Normal Alarm02 Fire 05 Final Exit04 24 Hr 06 Entry Route07 Technical 08 Key Switch Momentary10 Tamper 09 Key Switch Latched11 External PSU AC fail 17 Log Only12 External PSU Battery fault 18 Exit Terminate13 External PSU Low Volts 21 Lock Set14 External PSU Fault 24 Tamper Return15External Warning DeviceFault16 Hold Up Device FaultNote: If you assign a zone to more than one partition then that zone will only be set whenall the partitions it belongs to are set.When delivered from the factory, or if you restore the control unit to factory settings, thenall zones default to type Not Used (NU). When you assign a zone to a type other than NUthe control unit initially assigns the zone to partition 1.Once you have entered the Partitions menu, press  or  to scroll through the list ofpartitions followed by  or  to assign/de-assign the zone to each partition as necessary.If you wish to assign/de-assign the zones to many partitions then (for zones types thatallow this) you can use the “All Partitions” option (in between the first and last partitions onthe menu) to either assign or de-assign the zone to all partitions in one go, as follows:1. Press  or  to show “All Partitions” on the bottom line of the display.2. Press  or  to change the last word on the bottom right of the display to:“Yes” to assign the zone to every partition.“No” to de-assign the zone from every partition.3. Press  or  to scroll through the partition list and change the assignment of thezone as necessary.Note that if you de-assign a zone from every partition and then try to leave the menu bypressing  the control unit will display a warning and return you to the Partitions menu.Any zone that is in use (has a type other than “NU”) must be assigned to at least onepartition.Zone AttributesNote: This menu does not appear if a zone has the type “Not Used”, “HUA”, “Fire”, or“Keyswitch Momentary”.You can assign more than one attribute to a zone. Some attributes are not available forcertain zone types. In addition, some attributes may be unavailable for radio zones. Thedisplay shows only the available attributes for the zone type you select.To enable an attribute for a zone press  or  until the bottom line of the display shows“Yes” at the right hand end.