Defining trunk module types and settings 151Programming Operations Guide3 Select the service you want to change.A configuration screen appears in the right frame. The Translation mode default is None.4 The following table shows the possible settings for the services.Table 15 Module record valuesAttribute Value DescriptionTranslationModeNoneAllBy SIDBy NumberDefine how the system maps incoming digits for this service type tothe line number within the system.In all cases, the received digits are used to find a target line or toactivate remote access.Translation mode valuedefinitions:None: No mapping is applied. The last digits of the Called PartyNumber which match the Received Number Length setting are usedas received digits. Note that if there is no called party number (mayoccur with some FX calls) the call will ring at the incoming trunk primeset.All: Allows you to define the received digits used for all calls with thisservice type, regardless of the called party number or serviceidentifier (SID). For this option, all calls with this service type on thisPRI will ring the same target line.Depending on the service type and the protocol, you may be able tomap the called party number (By number) and the service identifier(SID).By SID: Allows you to associate different received digits with differentcalls of this service type based on the service identifier.By Number: Allows you to associate different received digits withdifferent calls of this service type based on party number.NOTE: Any calls that do not match any entry defined in the map tablewill ring at the prime set.Map Table Select Add on theMap Table screento create a new mapentryFrom digitsTo digitsEnter the incoming line number to the internal line number, such asthe target line.
