734 Selecting a permanent WAN link as the primary WAN connectionN0008589 3.3Enabling or Disabling Net Link Manager1 On the navigation tree, click the Services key and click the Net Link Mgr heading.The Net Link Manager Summary screen appears.2 Configure the Net Link Manager attributes according to the following table.3 Press the Tab key to save the settings.Selecting a permanent WAN link as the primary WANconnection1 On the navigation tree, click the Services key and click the Net Link Mgr heading.The Net Link Manager Summary screen appears.2 Click the Primary WAN Connection tab.The Primary WAN Connection screen appears3 Click the Mode box and click Permanent.4 Press the Tab key to save your choice.5 Click the Permanent WAN Connection Setting tabThe Permanent WAN Connection Setting screen appears.6 Configure the Permanent WAN Connections Setting attributes according to the followingtable.Table 212 Net Link Manager attributesAttribute DescriptionDescription Shows a description of Net Link Manager.Version Shows the version number of the subsystem.Status Shows the status of Net Link Manager. This box also provides commands to enable or disableNet Link Manager.Possible values: Up, Disabled, EnabledThe default value is: UpTable 213 Permanent WAN Connections settingsAttribute DescriptionNext Hop onPrimary LinkAllows you to enter the IP address (in dot format) of the next hop router.This address is used by Net Link Manager to add a default route in Business CommunicationsManager. If this address ever becomes unreachable, Net Link Manager dials the backup link andchanges the default route.This is usually the remote router of the primary WAN link.Up Poll Interval Allows you to set the polling interval on the Primary WAN Link, in seconds.The up poll interval is the interval between successive pings when the next hop on the primarylink is available.
