Configuring IP Routing global settings 711Programming Operations GuideConfiguring IP Routing global settingsThis section describes how to configure global settings for the IP Routing.It also includes information about:• “Setting the RIP Global Settings” on page 711• “Setting the OSPF Global Settings” on page 712To configure global settings for IP Routing:1 On the navigation tree, click the Services key and click the IP Routing heading.The IP routing Summary screen appears.2 Configure the Routing Summary attributes according to the following table.Setting the RIP Global SettingsIf your network uses RIP, configure the RIP Global Settings as described below. If your networkuses OSPF, refer to “Setting the OSPF Global Settings” on page 712.1 Click the RIP Global Settings tab.The RIP Global Settings screen appears.2 Configure the RIP Global Settings according to the following table.Table 201 IP Routing Summary attributesAttribute DescriptionDescription Shows a description of the router.Version Shows the version of the router.Status Shows you the status of the router. The possible values are:Up: the IP router is currently functioning.Enabled: allows you to enable the router.Disabled: allows you to disable the router.Table 202 IP RIP Global SettingsAttribute DescriptionRIP Log Level Allows you to enable the recording of events in the Event Viewer. The following options areavailable:Maximum, logs all information in the Event Viewer.Warnings Also, logs errors and warnings in the Event Viewer.Errors Only, logs errors in the Event Viewer.Disabled, disables event logs.The default value is Errors Only.Triggered UpdateIntervalAllows you to specify the minimum interval, in seconds, at which a router must send a routingtable update if the metric for a given route changes. If the router detects a change in the routinginformation, the router sends an update message at the specified interval.Possible values are 1 to 50000.The default value is 5.
