450 Setting up CAP stationsN0008589 3.33 Click the key beside CAP/KIM button programming.The following figure shows the programming field for button 01.Figure 151 Programming a CAP/KIM button.4 Click the button number that you want to program.5 Use the information in the following table to configure button preferences.Programming note: You cannot assign Hunt group DNs as an autodial button on the KIMmodules.Table 90 CAP/KIM feature button programming choicesSetting Values DescriptionType BlankFeatureInternal autodialExternal autodialChoose the type of feature that you want to program on thetelephone buttons.Blank means that nothing is programmed on the button.New KIM modules, for instance have all blank buttons whenthey are newly-installed.Value field:Feature <feature name> Use the arrow to choose the feature you want to program onthe button.Internal autodial <Internal DN> Enter the DN number for the internal telephone you want thetelephone to dial by pressing this button.External autodial Use prime linePoolUse routing tableUse lineChoose the route the telephone will dial through.Prime line: the prime line assigned to the telephonePool X: one of the pools assigned to the telephoneRouting table: enter the destination code with the externalphone numberUse line X: one of the lines assigned to the telephoneExternal #External autodial <dialing codes plus dialoutstring>Enter the complete dial sequence for the external call. Thissequence will depend on what you chose for the route in theValue field.
