Assigning Trunk/line data 251Programming Operations GuideAnswermodeManualAutoDefine whether a trunk is manual or automatic answer.Auto answer mode allows the trunk to be a shared resource by the systemtelephones.For auto answer trunks being used to allow remote call-in from system users, thetrunk can be configured to answer with a straight dial tone, if DISA has not beenenabled. It can also be configured to answer with a stuttered dial tone if DISA isenabled and the caller is expected to enter a COS password. The COS passworddefines which system features the caller is permitted to access.Manual answer trunks are assigned to one or more telephones. The assignedtelephones exclusively own the line.Note: You require Disconnect supervision on the line if loop start trunks are tooperate in auto-answer mode (Trunk mode).Answer withDISAY or N If Y, when a remote user calls into the system on an unsupervised line, the systemprompts a caller for a six-digit class of service (COS) password.If N, when a remote user calls into the system on an unsupervised line, the call isconnected as dialed.Link at CO Y or N Some exchanges respond to a Link signal (FEATURE 71) by providing analternative line for making outgoing calls.Enabling Link at CO causes the system to apply the restrictions on outgoing calls tothe digits dialed after the Link signal. As well, the call on the alternative line issubject to all restrictions.Disabling Link at CO prevents a Link signal from resetting the BusinessCommunications Manager restrictions in cases where the host exchange does notprovide an alternative line.You also need to ensure that telephones using the line have the feature allowed.Refer to “Defining telephone dialing restrictions” on page 453.Use auxiliaryringerY or N Turn the auxiliary ringer on or off for all telephones using this line.When programmed on a line, the auxiliary ringer will ring every time a call isreceived.Note: When programmed only on a telephone, no ring occurs for a transferred call.An auxiliary ringer can also be programmed in Services to ring for a line placed intoa scheduled Ringing service. Refer to “Configuring ringing service” on page 496Full autohold Y or N Enables or disables Full autohold.When enabled, if a caller selects an idle line but does not dial any digits, that line isautomatically placed on hold if you then select another line.The default setting should be changed only if Full autohold is required for a specificapplication.LossPackagesShort COMedium COLong COShort PBXLong PBXSelect the appropriate loss/gain and impedance settings for each line.For more information refer to “Using loss packages” on page 272.Impedance 600 ohm900 ohmThe GATM can be set to a specific impedance level. This is determined by localline requirements.Table 32 Loop start analog and digital fields (Continued)Attribute Value Description
