428 Defining user preferencesN0008589 3.3For information about configuring SWCA button controls, refer to “Programming SWCA controlsfor your system” on page 471. Use button programming to assign SWCA assignments to telephonebuttons with indicators. Refer to “Programming telephone buttons” on page 432.Defining user preferencesThe User preferences headings allow you to program the same settings that users can perform attheir telephones. These options are only available to digital/analog sets, IP telephones, and 7406cordless phones.Notes about portable handsets:• ISDN and WLAN IP telephones do not have user preferences.• Feature programming for the legacy NetVision telephones occurs through a separateconfiguration process, with the exception of 10 programmable buttons, which are specificallyused for two intercom positions, and eight SWCA key positions. Programming performed byusers at their own sets, takes precedence over these settings. User telephone programming andfeature programming for the NetVision telephones is described in the IP TelephonyConfiguration Guide and the NetVision Phone Administrator Guide.This section includes information about:• “Configuring user preferences” on page 429• “Programming telephone buttons” on page 432• “Configuring user speed dialing” on page 444• “Setting up CAP stations” on page 446Figure 137 User preference telephone settings* This heading only appears if a 7316E+KIM isconnected to the system.*Companion telephones only have thisUser Preference option.ISDN/DECT telephones have noUser Preferences.++
