Configuring the DDI Mux module 167Programming Operations Guide5 Click the Line assignment heading.6 Click on the line number you want to remove.7 Click the Delete button.8 On the confirmation dialog box, click the Yes button.Configuring the line for telephony1 Click the keys beside Services and Telephony Services.2 Click the keys beside Lines, Physical lines and All physical lines.3 Click the key of the line number you want to assign to telephony use.4 Click the Trunk/line data heading.5 Click the Trunk type drop list and then click on the correct type of trunk.Configuring the DDI Mux to work with the DTEAfter you have assigned the lines to the data module, you need to configure the DDI Mux so it canwork with the DTE.1 Click the keys beside Resources and Media Bay Modules.2 Click the key of the Bus number for the Data Module portion of the DDI Mux.3 Click the Data Module key and then click on Configuration.4 Configure the setting to match the DTE you are connecting to the DDI Mux.The following table describes the Data Module configuration settings.Table 18 DDI Mux Configuration settingsSetting Value DescriptionProtocol V.35 The DDI Mux supports a V.35 interface standard through its data interface port.You can select V.35.B channel datarate64 K56 KSelect the transmission rate per channel (Fixed data lines) assigned to themodule.Transmit clocksourceAutoDCEDTEThe DDI Mux requires a timing signal to clock data transmitted by the DTE. Thissignal can be supplied by the DTE or generated internally by the BusinessCommunications Manager. If the signal is generated by the DTE, the clock mustbe locked to the frequency of the DDI Mux clock.• Auto: The DDI Mux checks if the clock provided by the DTE is valid. If theclock is valid, the module uses DTE clocking. If the DTE clocking is not valid,the module uses its own internal clock (DCE).• DCE: The internal TxSync clock is used to clock data.• DTE: The TXClk clock provided by the DTE is used by the DDI Mux to clockdata.Note: Use the DTE option only for diagnostic purposes.For all options, the DTE must synchronize to the module.
