570 Meridian MCDN call features over PRI SL-1 linesN0008589 3.3Programming notesBusiness Communications Manager programming M1 programmingTo select Remote Capability for MWI on a per-loop basis for PRI:Resources, Media Bay Modules, Bus XX, Modules on bus,Module X:Remote Capability MWI = Y (if M1 has MWI package, with RCAPset to MWI)1. Disable the PBX D-channelassociated with IPT (LD96).2. Add MWI to the RCAP of theD-channel (LD 17 RCAP MWI)3. Ensure the RLS ID is a minimumof 25 (RLS ID 25).4. Re-enabled the PBX D-channel.Note: Package 219 is required onthe Meridian PBX to allow RCAPMWI.Note: If IP routing is being used, youmust complete this procedure on allthe D-channels in the privatenetwork.Turning on the service for IP trunks:Services, General Settings, IP Trunking:Remote Capability MWI = Y (if M1 has MWI package, with RCAPset to MWI)Telco features, VMsg Ctr Tel Numbers:• Voice Message Center 1 set to DES code plus M1 voice mailDNLines (target line), Telco features:• choose Voice message Center 1System DNs, Active set DNs, Line access, Line assignment:• assign target line to each set• in target line, VMsg set to Y
