270 Assigning Trunk/line dataN0008589 3.3Turn Privacy on or off for a callYou can configure lines in your system to have automatic privacy. With a line not programmedwith privacy, anyone with the line assigned to their telephone can join your call by pressing theline button. With a line programmed with privacy, one person at a time can use the line.Use Feature 83 to turn the privacy feature off and on.Privacy control cannot be used for internal or conference calls.When another telephone joins a call, the participants on the call hear a tone, and a message appearson the telephone display. It is not possible to join a call without everyone hearing this tone.Loop start analog LossPackagesShort COMedium COLong COShort PBXLong PBXSelect the appropriate loss/gain and impedance settings foreach line.For more information refer to “Using loss packages” on page272.DIDE&MSignaling WinkStartImmediateDelayDialSelect the signal type for the line. The immediate settingdoes not appear for T1 E&M or T1 DID trunks connected to aDTM if the Dial mode is set to tone.Make sure that this matches the signal type programmed forthe trunk at the other switch.DIDE&MANI Number Y or N Define whether the telephone number of the caller will becollected for this line.For T1 E&M and T1 DID trunks connected to a DTM, thissetting only appears if Signaling is set to WinkStart.The central office must deliver ANI/DNIS in DTMF mode. Noadditional equipment is required.E&M DNISNumberY or N Defines whether the digits dialed by an external caller on thisline will be collected.For T1 E&M trunks connected to a DTM,this setting only appears if Signaling is set to WinkStart andAnswer mode is set to Manual.These digits are required for some third-party softwareapplications.E&M *Gain NormalHighSet the level of gain for the channel.*E&M trunks only. T1 E&M trunks do not have this field.Loop Start (GATMonly)Impedance 600 ohm900 ohmThe GATM can be set to a specific impedance level.Loop start analogLoop start digitalGround start digitalDIDE&MTarget linesDASS2Redirect to Enter a dial string (including routing code) to redirect the lineto an external telephone, such as a call attendant on anothersystem.If you want to stop redirection, you need to delete the dialstring and allow the record to update.WARNING: Enable modulesIf you disabled any trunk media bay modules prior to performing programming, enable themnow to ensure your system will function properly.Table 41 Combined line settings table (Continued)Trunk types Attribute Value Description
