344 Configuring destination codes with wild cardsN0008589 3.3Enable/disable wild card digits1 Click on the key beside Wild cards.The valid numbers for the wild card forthis code are displayed.2 Click on the number you want to change.3 In the Wild card state field, chooseAssigned (can be used with thisdestination code) or Available (can beused as part of another destination code).4 Repeat steps 2 and 3 for all the numbersyou want to change.Setting up a destination for localcallingAn office can have different suppliers forlocal and long distance telephone service. Byprogramming a destination code, any call that begins with 9, which is the most common dial outdigit, automatically uses lines dedicated to local service.Note: 9 is the default setting for the line pool code for Pool A. If you want to use 9 as a destinationcode, you must change the Pool A code. Refer to “Assigning line pool access” on page 414.Follow these steps to build a route to allow local calls.1 Create a route that uses the line pool you assigned for the PSTN trunks. (“Defining routes” onpage 333).2 Create a destination code record and enter a destination code, such as 9, which is a commonlocal call code. (“Configuring destination codes with wild cards” on page 342)For local calls only, there are no dial out numbers (compare with “Setting up a route through adedicated trunk” on page 345).The destination code can use a different route, depending on what schedule is assigned. In thecurrent example, the route you define is used when someone dials 9 during Normal mode,when the other Schedules are turned off.3 Set up the Normal schedule with the route number you defined in step 1.
