Configuring an analog device DN record 881Programming Operations GuideTo assign line pools1 Click on the Line pool access heading in the DN record.2 Click the Add button.3 Enter a line pool identifier. <- Pool A to O>.4 Click the Save button.The line pool identifier appears under the Line pool access heading.To assign a prime line1 Click on the Line access heading in the DN record.Figure 225 Line access screen exampleCaller ID set Y or N This setting only appears for analog lines that provide CLID.This setting is for analog display telephones connected to an ASM 8+module using the North American profile.Choose Y to enable an analog display telephone to receive call displayinformation.Note: Not all analog display telephones are equipped to receive CLID.Choose N to disable the analog telephone from receiving call displayinformation. Use this setting if the telephone does not have a display, orif you do not want to provide call information to the user. Disabling thisfunction can reduce system resource requirements.Limitation: Only 30 telephones can have this field enabled for any givenline.Vmsg set N or Y Choose Y to enable an external voice message system to sendMessage Waiting Indication (MWI) to the analog telephone.Analog telephones attached to an ASM or ATA2 device can only receivestutter dial tone indication, if the telephone is set up to receive MWI.Analog telephones connected to an ASM8+ can receive either lamp orstutter dial tone indication, if the telephone is set up to receive MWI.Refer to “Msg Indicate” on page 886 for more information on how toenable MWI for an analog telephone.Table 286 Line assignment fields (Continued)Attribute Values Description
