Defining trunk module types and settings 153Programming Operations GuideProvisioning BRI loops/linesIn order to provision lines on a BRI module you must first provision the loop on which the linesexist.1 Click the keys beside Resources and Media Bay Modules.2 Click the key beside the bus number (Bus 02 to 07) associated with the trunk module you wantto provision.3 Click the key beside Modules on Bus.4 Choose the BRI module where you want to provision loops.5 Expand Provision Loops.All the available loops appear as Loop headings.6 Click the Loop you want to provision.7 In the Status box, click Provisioned.8 After provisioning one or more loops on the module:a Refresh the Loop entry and you will see two Line <number> entries underthis loop.b Click on the Line you wish to provision.c In the Status box, click ProvisionedDeprovisioning a line/loopWhen you are not using a line/loop, or when you want to cancel it, you can deprovision that line orloop.Follow these steps to deprovision a line/loop:1 Click the keys beside Resources and Media Bay Modules.2 Click the key beside the bus number (Bus 02 to 07) associated with the module you want toprovision.3 Click the key beside Modules on Bus.A list of the modules assigned to the Bus appears.4 Choose the module you want to provision.For example, click on Module 1.5 Click the key beside Provision lines or Provision Loops.All the available lines/loops appear.6 Choose the line/loop you want to deprovision.7 From the Status box, click Deprovisioned.Use this procedure if your system configuration requires/receives fewer than the standard numberof channels delivered from the PRI line. This is called Fractional T1/PRI. Your service providermight offer you Fractional T1/PRI service to address specific needs on your system.
