YASKAWA E-S Series Product Manual

Contents

xi Storage Precautions Transportation PrecautionsCAUTION Do not place an excessive load on the product during storage. (Follow all instructions on thepackages.)There is a risk of injury or damage.NOTICE Do not store the product in any of the following locations.• Locations that are subject to direct sunlight• Locations that are subject to ambient temperatures that exceed product specifications• Locations that are subject to relative humidities that exceed product specifications• Locations that are subject to condensation as the result of extreme changes in temperature• Locations that are subject to corrosive or flammable gases• Locations that are near flammable materials• Locations that are subject to dust, salts, or iron powder• Locations that are subject to water, oil, or chemicals• Locations that are subject to vibration or shock that exceeds product specifications• Locations that are subject to radiationIf you store the product in any of the above locations, the product may fail or be damaged.CAUTION When you touch the SERVOPACK, hold the edges of the SERVOPACK board, and never touchthe surfaces of the components or the surface of the solder.There is a risk of injury or malfunction. When you move the product after removing it from the package, take adequate measuresagainst static electricity.There is a risk of electric shock or failure. When you handle a SERVOPACK or Servomotor, be careful of sharp parts, such as the corners.There is a risk of injury. Do not place an excessive load on the product during transportation. (Follow all instructions onthe packages.)There is a risk of injury or damage.NOTICE Discharge any static electricity from your body before you touch a SERVOPACK.There is a risk of equipment damage. A SERVOPACK or Servomotor is a precision device. Do not drop it or subject it to strong shock.There is a risk of failure or damage. Do not subject connectors to shock.There is a risk of faulty connections or damage. If disinfectants or insecticides must be used to treat packing materials such as wooden frames,plywood, or pallets, the packing materials must be treated before the product is packaged, andmethods other than fumigation must be used.Example:Heat treatment, where materials are kiln-dried to a core temperature of 56°C for 30minutes or more.If the electronic products, which include stand-alone products and products installed in machines,are packed with fumigated wooden materials, the electrical components may be greatly damagedby the gases or fumes resulting from the fumigation process. In particular, disinfectants containinghalogen, which includes chlorine, fluorine, bromine, or iodine can contribute to the erosion of thecapacitors.