YASKAWA E-S Series Product Manual

Contents

3.5 SERVOPACK Installation3.5.2 Mounting and Securing SERVOPACKs3-103.5.2 Mounting and Securing SERVOPACKsThe Σ-S-Series SERVOPACKs are PCBs, so they are secured to the equipment with studs orother mounting fixtures. This section describes the installation procedure.Required Item• Mounting fixtures (mounting screws, studs, etc.): M3 × 3 (made of metal)• Screwdriver1. Prepare studs on the equipment that match the three mounting holes on the SERVO-PACK.2. Place the SERVOPACK on the prepared studs and secure it to the studs with screws.(Tightening torque: 0.49 N⋅cm)This concludes the SERVOPACK installation procedure.3.5.3 Installation OrientationYou can install the SERVOPACK either horizontally or vertically.Note: Secure the cables on the equipment so that they do not place a load on the SERVOPACK.NOTICE Remove all static electricity from your body before you install a PCB. Never touch the elec-tronic components mounted to a PCB with your bare hands.There is a risk of equipment damage.Mounting holesMountingholesDevicemountingsurfaceStudsSERVOPACK(PCB)MountingscrewsSERVOPACK (PCB)