Zeiss LSM 510 Manual

Also see for LSM 510: Quick start

LSM 510 Routine ModeLSM 510 META Application of Examination Methods in … Carl Zeiss03/06 B 45-0021 e 6-15The following functions are available on the right side of the this window:New Image button Opens a new image window.Start T button Starts the time series.Stop button Stops the entire time series. A current scan is canceled.Pause button Interrupts the time series. The button labeling changes to Resume. Acurrent scan is performed until its end. Pressing the Pause button againwill resume the time series.Stage button Opens the Stage and Focus Control window.(1) Start Series panelDepending on the imported examination method,the time series can be started and ended manually,via trigger or by entering a time (computer time).In the Start Series & Stop Series panel, therelevant mode is displayed. Switching betweenmanual, trigger and time control is not possible inthe Routine mode.(a) Manual start of a time series• You can take over the offered parameters by clicking on the Start T button.− The time series is recorded and displayed in the image window.• Click on the Stop button to end the time series.(b) Starting a time series via trigger• The Start T button must be pressed first to start a time series via trigger.− Waiting for Trigger will be displayed in the status line.• Then the relevant trigger key of the Trigger Control must be pressed to start the first scan procedureof the time series.• The time series is ended by pressing the relevant trigger key.If the number of cycles entered under Number has been processed without a trigger impulse havingbeen given to end the procedure, the time series is finished.If a trigger signal is given before the cycles have been processed, the time series will only be interrupted.Waiting for Trigger will be displayed in the status line. The time series can now be continued via a newtrigger signal or ended via Stop.Fig. 6-20 Start & End panel