STATUS LOG7-52 Edition One XC1000 ServiceTable 7-28. Status-Code Entries in the Status Log (Concluded).StatusCode DescriptionEA DLC data-bus errorEB Message library failureEC IVR message directory errorF0a Invalid response to drive test messageF1a Soft error status returnedF2a Hard error status returnedF3a ECC soft errorF4 Bad AMIS message array found or software errorF5 Failed to write AMIS message array back to diskF6 Bad AMIS dialing sequence table found or software errorF7 Failed to write AMIS dialing sequence table back to diskF8 SP AMIS I/O errorF9a Integration general errorFAa InterMail error—VPMOD-to-Host taskFBa InterMail error—Host-to-VPMOD taskFC Error in overflow event taskFD File access errora Explained further in this chapter.7.4 HIGHLIGHTS The XC1000 reports system status in the status log. Entries in thestatus log are used to monitor and troubleshoot the system. The information in this chapter can be used to interpret the structureand meaning of the most common status-code entries. The status log can be viewed and printed by entering menu 13, option 2,on the system manager terminal. Status codes are located at offsets 04 and 05 in a status-log entry. A status-code 00 entry appears each time the system is restarted. Line–task (port) or integration errors generate the most entries. The start of the CB message varies with each status-code entry. The most serious status-code entries are 57, 64, 70, 72, 98, CD, andCE. Act immediately to correct any of these situations. Garbage collect should not be run if user records have been damaged.SECTION 7.3 – 7.4
