RELEASE 1.55 UPGRADE INSTRUCTIONS12-5Edition OneXC1000 Service16. When the prompt CHECK DONE—PRESS ANY KEY TO CONTINUEappears, press any key; then verify that no errors were reported forany mailbox (from the printouts).If there are any discrepancies, before continuing with the softwareupgrade, contact the Octel Communications Technical AssistanceCenter.17. Turn off the continuous-printing mode by pressing the Copy Pr keyon the HP 700/43 terminal or the Ctrl, Shift, and Print keys on theWyse 50 terminal.12.5 RUN GARBAGE COLLECTDo not run garbage collect with the master drive installed.If garbage collect is run with the master drive in systemdrive-slot 0 (S0), all messages will be lost.Caution!Perform the following steps to run garbage collect:1. Coordinate with the system manager before taking the XC1000 out ofservice.2. If a data module is connected to the XC1000, the X.25 link must bestopped before running garbage collect. Access Menu 18 – X.25Interface Management from the Main Menu.3. From menu 18, select option 3 to access menu 18.3, X.25 InterfaceOperation.4. In the Physical Interface Number: field, enter the number of theXC1000 DB25 connector to which the X.25 link is connected andpress the Enter key. Valid interface numbers are 0 and 1.5. In response to the prompt at the bottom of the screen in menu 18.3,type 2 for Immediate Stop and press the Enter key. Press ^C or theBreak key until the Main Menu reappears.6. From the Main Menu, type the current date at the Enter MenuSelection Number: prompt, in the format mmdd. Press the Enter key.7. At the > prompt, turn on continuous-mode printing by pressing theCopy Pr key on the HP 700/43 terminal or the Ctrl, Shift, and Printkeys, simultaneously, on the Wyse 50 terminal. This process allowsthe results of the garbage-collect utility to be printed. All screens willbegin printing starting with the reformat menu.8. At the > prompt, type REFORMAT and press the Enter key.9. When the reformat menu appears (Figure 12-2), type 4 and press theEnter key to select the Garbage collect option.SECTION 12.4 – 12.5
