RELEASE 3.02 ONLINE UPGRADE INSTRUCTIONS15-2 Edition One XC1000 Service20. Ensure that the correct equipment is available (section 15.3).21. Enable the engineering bit (section 15.4).22. Determine the correct system manager terminal (SMT) port baud rateof the XC1000 (section 15.5).23. Verify the system boot area (section 15.6).24. Connect the hardware between the PC and the XC1000 (section 15.7).25. Install online upgrade tool 1.00 on PC hard drive (section 15.8).26. Verify the setup in the Setup menu (section 15.9).27. Load software and phrase diskettes on the PC hard drive (section15.10).28. Begin the automatic upgrade (section 15.11).29. Reconnect the system manager terminal and verify the upgrade(section 15.12).30. Reset the boot area to run the XC1000 on new software (section 15.13).31. Disable the engineering bit (section 15.14).32. Make software and phrase areas redundant (section 15.15).If the online upgrade fails at any point during the proce-dure, call the Octel National Response Center (for nationalaccounts) or the Octel Technical Assistance Center (TAC)for assistance. Do not attempt to resolve problem(s) byyourself.Caution!15.3 ENSURE THAT THE CORRECT EQUIPMENT ISAVAILABLEThe following equipment is required for performing an online upgrade fromRelease 3.0 to Release 3.02.Do not begin an online upgrade unless all equipment isavailable.Caution!15.3.1 Determining Hardware and FirmwareThe following hardware and firmware are required to perform an onlineupgrade from Release 3.0 to Release 3.02.SECTION 15.2 – 15.3
