RELEASE 2.X UPGRADE INSTRUCTIONS13-18 Edition One XC1000 Service5. Upon completion of the second pass, a screen similar to the one inFigure 13-13 appears. If SC or I/O errors are reported during thesecond pass, call the Octel Communications Technical AssistanceCenter.# Scramble Code Errors = 0# I/O Errors = 0# Messages (Destinations) = 0# AMIS EARS = 0# Users with bad messages = 0# Users with bad grouplists = 0# Nodes with bad messages = 0# bad IVR Directory messages = 0# bad AMIS Directory messages = 0# bad FAX queue messages = 0Press any key to continue.05 MAR 93 Garbage Collection 01:37:56PMPort Msgs Blks BOS Tot BOS ActTOTAL 0 0 0 0Garbage Collect CompletePress any key to continue.Figure 13-13. Garbage Collect, Second Pass.6. When the Garbage Collect Complete message appears, turn offcontinuous-printing mode by pressing the Copy Pr key on the HPterminal or the Ctrl, Shift, and Print keys on the Wyse 50 terminal.7. Press any key to return to the > prompt.8. Type ^C to return to the Main Menu.9. If the X.25 link was stopped in section 13.5, restart the link usingmenu 18.3.13.14 CONFIGURE THE SERIAL CHANNEL PARAMETERSThese procedures are only required for XC1000s being upgraded fromsoftware levels below 1.5X. If upgrading from 1.5X to 2.X, skip to section13.15. Menu 6 has a new name and has three new submenus added.These changes and the added submenus allow greater versatility inaccessing and managing the XC1000.Figure 12-13 shows menu 6. Menus 6.3, 6.4, and 6.5 are discussed in thefollowing sections. For additional information about menu 6, refer toChapter Twelve and Addendum II of the the Release 1 XC1000 SystemManager Manual.SECTION 13.13 – 13.14
