RELEASE 3.02 ONLINE UPGRADE INSTRUCTIONS15-4 Edition One XC1000 Service T1 TICs, P/N 044–2002–000, with EPROMs:Low byte, P/N 039–1289–000, revision 9000 or higherHigh byte, P/N 039–1290–000, revision 9000 or higher ACP–10 card, P/N 044–2039–XXX, * with the following EPROMs:Low byte, P/N 039–1372–000, revision A (9101) or higherHigh byte, P/N 039–1373–000, revision A (9101) or higherTwo 188 Code, P/N 039–1408–001, revision 9203 (or higher)15.3.2 Specifying SoftwareSoftware and phrase diskette names depend on the voice-processing moduletype and configuration and the languages supported. The Xs in the namesare variables only. The following software is required to perform an onlineupgrade: Online upgrade tool diskette 1.00, P/N 116–1086–000. Software diskette(s); for example, MS300XXX.SSU, P/N 316–0012–000,diskettes are for mainstream software. Phrase diskette(s) as necessary, for example, 9033XXXX.SPU, P/N316–XXXX–XXX. Specific part numbers for phrase diskettes aredetermined at the time of a new phrase(s) release. DOS 5.0 or higher.15.4 ENABLE THE ENGINEERING BITPerform the following steps to enable the engineering bit:1. Call the Octel National Response Center (for national accounts) or theOctel Technical Assistance Center to have the engineering bit turnedon. Be prepared to provide the pilot number of the hunt groupassigned to the XC1000.2. Wait for confirmation from the Octel National Response Center (fornational accounts) or the Octel Technical Assistance Center that theengineering bit has been enabled.15.5 DETERMINE THE CURRENT BAUD RATE FORSYSTEM MANAGER TERMINAL (SMT)Determine the current XC1000 SMT baud rate before beginning an onlineupgrade so that the PC-to-XC1000 connection can be set up correctly. If the SMT is connected to the SMT-allocated (J50) port, the baud rateis set to 9600. If the SMT is connected to a flexible port, then the baud rate could beconfigured to 9600 or 19200.SECTION 15.3 – 15.5
