RELEASE 1.55 UPGRADE INSTRUCTIONS12-7Edition OneXC1000 Service14. When the GARBAGE COLLECTION SUCCESSFUL prompt appears,turn off continuous-printing mode by pressing the Copy Pr key on theHP700/43 terminal or the Ctrl, Shift, and Print keys on the Wyse 50terminal.15. Press ^C, twice, to return to the Main Menu.16. If the X.25 link was stopped in step 5, restart the link in menu 18.3.12.6 BACK UP SYSTEM-DRIVE 0Perform the following steps to back up system-drive 0:1. Shut down the system using menu 13, option 1, suboption 2.2. When the ENTER BOOT COMMAND: prompt appears, turn theXC1000 power off at the main circuit breaker; allow the drives to spinall the way down.3. Open the doors on the front of the XC1000.4. Place the backup drive in system drive-slot S2.5. Turn on the power to XC1000.6. When the ENTER BOOT COMMAND: prompt appears, type ^DI toenter the INSTALL OPTIONS: menu.7. Select option D – INITIALIZE DRIVE to initialize the backup drive (inslot 2) as a system drive.8. When the backup drive is initialized, press ^C twice to exit to theENTER BOOT COMMAND: prompt.9. Type ^DC at the ENTER BOOT COMMAND: prompt to enter the COPYOPTIONS: menu, as shown in Figure 12-5.10. Type D to select the SYSTEM [ALL OF THE ABOVE] option to copythe software, phrases, and database from drive 0 to drive 2.The source is drive 0, the alternate source is drive 1, and thedestination is drive 2. Verify that the serial numbers displayed arecorrect. The destination drive is not a replacement drive. Figure 12-6shows a completed screen for this operation. Each time a response isentered, a new prompt or message appears.11. After the copy operation is completed, press any key to return to theCOPY OPTIONS: menu (Figure 12-5). Type X to exit the menu.12. When the ENTER BOOT COMMAND: prompt reappears, turn off powerto the XC1000.13. Remove the backup drive from drive-slot S2 and clearly label it as thebackup.SECTION 12.5 – 12.6
