RELEASE 3.02 FCP CONVERSION INSTRUCTIONS14-21Edition OneXC1000 Service1. Make sure that the XC1000 SMT is displaying the Main Menu. Openthe doors of the XC1000.2. Disconnect the SMT cable, P/N 057–1174–000, from the back of theterminal. Plug the adapter end into a DB25/DB9 adapter, P/N003–1091–000, and plug into the PC COM1 port.3. Leave the other end of the cable, P/N 057–1174–000, plugged intoSMT port J50. Set aside the terminal.4. Plug one end of the second cable, P/N 057–1174–000 into a 25-pinmale/25-pin female null modem connector, P/N 003–1115–000, andthen into flexible port J43.5. Plug the other end of the second cable into a DB25/DB9 adapter, P/N003–1091–000, and then into the PC COM2 port.6. If the PC COM ports have 25-pin male connections, plug two female/female DB25/DB25 gender changer adapters, P/N 003–1092–000, intothe PC COM ports.7. Make sure that the cabling connections are correct.Figure 14-12 is a representation of the hardware configuration forconnecting the PC to the XC1000.COM2 (SMT PORT)COM1BCBCJ43J44J45AAXC1000 BACKJ46J47J48J49J50NULL MODEM,A = 25-PIN MALEB = 25-PIN FEMALEC = 9-PIN FEMALEJ43 CABLE (P/N 057–1174–000) PLUGSINTO PC COM2 PORT (9–PIN MALE).J50 CABLE (P/N 057–1174–000) PLUGSINTO PC COM1 PORT (9–PIN MALE).ADAPTER,P/N 003–1091–000P/N 003–1115–000CABLE, PN 057–1174–000(ADAPTER INCLUSIVE)** IF THE PC COM PORTS HAVE 25-PIN MALE CONNECTIONS, USE FEMALE/FEMALE DB25/DB25 GENDER CHANGERADAPTERS, P/N 003–1092–000.Figure 14-12. Representation of the PC-to-XC1000 Connection.14.9 PERFORM THE FCP CONVERSIONWith the PC connected to the XC1000, perform the FCP conversion as follows:1. If the XC1000 system manager terminal was disconnected when theMain Menu was displayed and the PC displays the FCP conversionMain Menu (Figure 14-4), skip to step 2. Otherwise, perform thefollowing procedure:SECTION 14.8 – 14.9
