RELEASE 3.0 SYSTEM UTILITIES16-21Edition OneXC1000 Service2. At the Enter drive to be installed [S0–S3, M0–M6]: prompt, enterthe number of the drive to be installed.3. At the Is this the correct drive? (y/n): prompt, enter Y if the serialnumber of the drive is correct.4. At the Install replacement [drive type] drive [number] (y/n): prompt,enter Y to install the replacement or N to cancel the installation. If Yis entered, the XC1000 installs the drive, as follows: Reads the boot table of the drive being installed. If the file cardcannot install the drive successfully, control-bus messages aredisplayed. CB IN reports 01 in offset 03. Writes the serial number of the selected drive to the new tableon system drives 0 and 1. Updates the amount of available free space if the new drive is amessage drive, as shown in SMT menu 12.5. When the initialization is complete, press any key to return to theDrive Replacement Utilities menu.6. Type ^C to return to menu 20.Figure 16-19 is an example of a completed screen for the Install Replace-ment Drive utility.Install Replacement Drive UtilityEnter drive to be installed[S0–S3, M0–M6]: S0Drive Serial No: M002042Is this the correct drive? (y/n): yInstall replacement System drive 0 (y/n): yInstalling messagesProcessing AMIS Directory recordsProcessing IVR Directory recordsProcessing Network Node recordsProcessing FAX Queue recordsProcessing NameNet recordsInstall Drive CompletePress any key to continue.Figure 16-19. Example of Prompts and Responses forthe Install Replacement Drive Utility.16.5 DRIVE INSTALL UTILITIESThe Drive Install Utilities menu provides options for installing drives,deinstalling drives, and initializing the system. These utilities which areavailable only in the offline mode, are described in sections 16.5.1 through16.5.3. From menu 20, enter the corresponding menu-item number at theEnter Choice: prompt to access the Drive Install Utilities menu, shown inFigure 16-20.SECTION 16.4 – 16.5
