RELEASE 1.55 UPGRADE INSTRUCTIONS12-8 Edition One XC1000 ServiceCOPY OPTIONS:A – SOFTWAREB – PHRASESC – SYSTEM DATA TABLES [USER RECORDS, SST, SGL, COS, BTIL]D – SYSTEM [ALL OF THE ABOVE]E – MESSAGESF – ADD SECTOR TO BAD SECTOR TABLEG – CLEAR BAD WRITE TABLEH – RESET THE CDR POINTERSI – DISK UTILITYJ – PHRASE RECORD UTILITYK – REPLACE DRIVEU – UPGRADE SYSTEM DRIVEV – VERIFY DRIVE FOR INTEGRITYX – EXITSELECT COPY OPTION:Figure 12-5. COPY OPTIONS: Menu.ENTER SOURCE DRIVE LOCATION: 0ENTER ALTERNATE SOURCE DRIVE LOCATION: 1ENTER DESTINATION DRIVE NUMBER (0–3): 2COPY ENTIRE SYSTEM FROM DRIVE 0, SN: MXXXXXXX TO DRIVE 2, SN: MYYYYYYYCONTINUE (Y OR N)?WILL DESTINATION DRIVE BE A REPLACEMENT (Y OR N)? NVERIFYING SOURCE...COPYING...VERIFYING DESTINATION...COPY COMPLETEPRESS ANY KEY TO CONTINUEFigure 12-6. System-Drive 0 Backup to Drive 2.12.7 UPGRADE THE HARDWAREMake sure that the XC1000 has the appropriate level of hardware installedbefore performing the software upgrade. Refer to section 12.2 for a list ofthe correct hardware for Release 1.55.12.7.1 Check the HardwarePerform the following steps to upgrade the XC1000 hardware (logic cardsand EPROMs) to the appropriate revision levels. If hardware must bereplaced, have the appropriate tools on hand, for example, an EPROMpuller and the SIMMs extraction tool. Put aside the old EPROMs until theXC1000 is upgraded successfully, in case they must be reinstalled.SECTION 12.6 – 12.7
