1313-1Edition OneXC1000 ServiceRELEASE 2.X UPGRADE INSTRUCTIONS13.1 OVERVIEWThe major steps when upgrading to Release 2.X or custom Releases B.13,N.30, or W.40 are as follows:4. Verify that all required equipment is available.5. Enable the service option.6. Run validity checks.7. Run garbage collect.8. Back up system-drive 0.9. Upgrade the hardware.10. Install the EMI shielding kit.11. Upgrade new software and phrases to system drives.12. Convert node records to user records.13. Convert system-distribution lists to mailboxes.14. Move company records and attendant schedules to user records.15. Run online validity checks and garbage collect.16. Configure the serial channel parameters.17. Enable the special message-waiting feature for SMDI integrations.18. Return the XC1000 to service.Figure 12-1 shows a flowcharted overview of the upgrade. This upgradeusually requires that the XC1000 be out of service for at least 3 hours.This time can vary, depending on the XC1000 configuration.The procedure for updating a XC1000 to a new version of Release 2.X froma previous version of 2.X is described in section 13.17. This procedure alsoapplies to custom Releases B.13, N.30, and W.40.13.2 VERIFY THAT ALL REQUIRED EQUIPMENT ISAVAILABLEMake sure that all required hardware is available before beginning theupgrade. The following hardware is required for upgrading XC1000 toRelease 2.X: Master-drive module Backup-drive module Certain hardware revision levels installed for Release 2.XTo verify that existing hardware is compatible with the new software, referto Appendix E, EPROM Configuration and Software Matrix. Hardwarerequirements for Release 2.X are as follows:
