RELEASE 3.02 ONLINE UPGRADE INSTRUCTIONS15-18 Edition One XC1000 Service5. At the Enter area (A or B): prompt, type the letter designating thearea not currently used as the system boot area. Then press theEnter key.6. Press ^C to return to the SMT Main Menu.7. At the SMT Main Menu prompt, type 13 and then press the Enter keyto select the Menu 13 – System Maintenance option.8. At the Menu 13 – System Maintenance menu, type 1 and then pressthe Enter key to select the 1 – Shut Down with Dump option.9. At the Enter “1” – allow lines to clear, “2” immediate shutdown,“Break” – Cancel: prompt, type 1 and then press the Enter key toallow lines to clear before shutdown. After the shutdown, the XC1000reboots into the new software, Release 3.02.15.14 DISABLE THE ENGINEERING BITCall the Octel National Response Center (for national accounts) or the OctelTechnical Assistance Center to have the engineering bit turned off.15.15 MAKE SOFTWARE AND PHRASE AREASREDUNDANTRelease 3.0 introduced multiple software areas to the XC1000 to allow anupgrade to be performed online and to allow software Release 3.02 to berun on a trial basis, with the option of returning to the previous release.The XC1000 should now be running at software Release 3.02,with Release3.0 in the nonboot area. Octel recommends that the XC1000 be run byalternating software in areas A and B for approximately 1 week to be surethat the XC1000 is running smoothly.If problems arise with software Release 3.02, call yourOctel Service Representative immediately. Do not attemptto correct the problem(s) yourself.Caution!If the XC1000 is running smoothly with software Release 3.02, perform thefollowing steps to make software areas redundant:1. Call the Octel National Response Center (for national accounts) or theOctel Technical Assistance Center to have the service bit turned on.Be prepared to provide the pilot number of the hunt group assigned tothe XC1000.2. Wait for confirmation from the Octel National Response Center (fornational accounts) or the Octel Technical Assistance Center that theservice bit has been enabled.SECTION 15.13 – 15.15
