RELEASE 4.X FCP CONVERSION INSTRUCTIONS17-11Release 4.XXC1000 Service17.7 LOAD MIRROR SOFTWARE, FCP CONVERSIONTOOL, AND SOFTWARE AND PHRASE DISKETTESON THE PC HARD DRIVEPrepare to load software onto the PC hard drive as follows:1. Make sure that the PC is plugged into an electrical wall outlet.2. Make sure that DOS 5.0 or newer is already installed on the PC harddrive. If it is not, install DOS before proceeding. For assistance, referto the DOS software manual.3. If screen-saver software is installed on the PC, disable the softwarefor the FCP conversion by modifying c:\autoexec.bat on the PC. Forassistance, refer to the screen-saver software manual.If unable to disable the screen-saver software, whenever the screenblanks out during the procedure, press Shift to refresh the screen.4. If power-management or battery-conservation software is installedon the PC, disable the software for the FCP conversion by modifyingc:\autoexec.bat on the PC. For assistance, refer to the softwaremanual.Do not run an FCP conversion on a laptop PC battery. ThePC must be plugged into an electrical wall outlet. Other-wise, the conversion might fail due to loss of battery power.Caution!5. If you are using a laptop PC for the upgrade, make sure that thelaptop PC is plugged into an electrical wall outlet. Do not run an FCPconversion on a laptop PC battery.6. If an FCP conversion was previously done using the same PC, skip tosection 17.7.3.17.7.1 Installing SoftKlone MIRROR III Software, Version 2.5Install SoftKlone MIRROR III software, version 2.5 onto the PC hard driveas follows:1. If the PC is running Windows software, exit Windows.2. Insert the MIRROR Program diskette into diskette drive a: (or b:,if appropriate).3. At the DOS C:\> prompt, type a: (or b:) and press Enter.4. At the A:\> prompt (or B:\> prompt), type install and press Enter.An INSTALLATION MENU appears.5. Press Enter to select the Mirror III 2.5 option.SECTION 17.7
