1414-1Edition OneXC1000 ServiceRELEASE 3.02 FCP CONVERSION INSTRUCTIONS14.1 OVERVIEWThis procedure differs significantly from previous upgradeprocedures. Review this entire document carefully beforebeginning an online upgrade.Caution!A file-card-primitives (FCP) conversion from Release 1.5X or 2.X to Release3.02 differs from upgrades for previous software releases. In previousreleases, upgrades consisted of copying software and phrases from a masterdrive to the XC1000. An FCP conversion uses a PC with Octel-proprietarysoftware diskettes to upgrade the XC1000. Equipment required to performan FCP conversion is listed in section 14.3.The following FCP conversion prerequisites or requirements must beconsidered before beginning an FCP conversion:Do not attempt to perform an FCP conversion fromsoftware releases older than Releases 1.5X or 2.X. TheFCP conversion will fail.Caution! If the XC1000 is currently at a release older than Release 1.5X or 2.X,upgrade the XC1000 to Release 1.5X or 2.X before beginning an FCPconversion. Order the appropriate upgrade kit from Octel to upgradethe XC1000 to Release 1.5X or 2.X. The XC1000 must be completely functional at Release 1.5X or 2.X.Resolve all problems or status-log entries on the XC1000 beforeperforming an FCP conversion.Do not begin an FCP conversion if the user-recordavailability does not meet the requirements set forth insection 14.5. The FCP conversion will fail.Caution! For FCP conversions from Release 1.5X, the XC1000 must haveenough user records available to accommodate the new Release 3.02software and phrases. Perform the steps in section 14.5 beforecontinuing with the procedures following.
