Chapter 5: Using the PX3TS106Number Example informationThe word "MASTER" indicates the PX3TS is the masterdevice in a cascading chain.For a slave device, it shows "SLAVE" instead.Note: As of release 3.3.10, the "MASTER/SLAVE"information is no longer available in the Bridging mode,but remains available in the Port Forwarding mode.The measurement unit is (degrees in Celsius).To display the environmental sensor information:1. Press the MODE button until this product enters the Sensor mode,as indicated by "SENSOR" at the top of the LCD display.2. Press the Up or Down button until the desired environmentalsensor's ID number is displayed.3. For example, "SENSOR 1" refers to the sensor #1 listed on thePX3TS web interface.4. The LCD display shows the reading or state of the selected sensorin the middle of the LCD display. When showing a numeric sensor's reading, the appropriatemeasurement unit is displayed to the right of the reading.MeasurementunitsSensor types% A relative humidity sensorA temperature sensorm/s An air flow sensorPa An air pressure sensorNO measurementunitsFor an "absolute" humidity sensor, themeasurement unit is g/m 3, which cannot bedisplayed on the LCD. Available states for a state sensor:States Descriptionnor Normal state.
