Chapter 8: Using the Command Line Interface604Specifying the CC Sensor TypeRaritan's contact closure sensor (DPX-CC2-TR) supports the connectionof diverse third-party or Raritan's detectors/switches. You must specifythe type of connected detector/switch for proper operation. Use thiscommand when you need to specify the sensor type.config:# externalsensor sensorSubType Variables: is the ID number of the environmental sensor that you want toconfigure. The ID number is available in the PX3TS web interface orusing the command "show externalsensors " in the CLI. It isan integer between 1 and 32. is one of these types:contact,smokeDetection,waterDetection orvibration.Type Descriptioncontact The connected detector/switch is for detection ofdoor lock or door closed/open status.smokeDetection The connected detector/switch is for detection ofthe smoke presence.waterDetection The connected detector/switch is for detection ofthe water presence.vibration The connected detector/switch is for detection ofthe vibration.Setting the X CoordinateThis command specifies the X coordinate of an environmental sensor.config:# externalsensor xlabel ""Variables: is the ID number of the environmental sensor that you want toconfigure. The ID number is available in the PX3TS web interface orusing the command "show externalsensors " in the CLI. It isan integer between 1 and 32. is a string comprising up to 24 ASCII printablecharacters, and it must be enclosed in quotes.
