Chapter 5: Using the PX3TS119PDUDepending on the model you purchased, the "PDU" menu command mayshow one or all of the following data. Internal beeper states -- On or Off Total active power Total active energy Energy pulse output settings -- available on PX3TS-5000 series only 12V power supply statusTip: The internal beeper state information is also available in the PX3TSweb interface. See PDU(on page 176).To view or configure PDU information:1. Press or to select "PDU" in the Main Menu, and press.2. The internal beeper state is shown: Active or Off. In the Active state, the reason of turning on the beeper isindicated, and the top/bottom bars turn red.3. If your PX3TS is a PX3TS-5000 model, it supports the active energypulse output. Press to enter the Energy Pulse page.By default the energy pulsing is turned off. DO NOT enable thisfeature unless you have to use it.Note: This feature, once enabled, blink all outlet LEDs proportionalto the energy consumption. It can be used as a simple interface incertification labs where they use an optical sensor to count thenumber of pulses and compare it to the energy reading of areference meter.a. To change the energy pulse settings, press .b. Press or to select an option.c. Press to confirm the selection, or to cancel.Note: All outlet LEDs on the PX3TS turn OFF after enabling theenergy pulsing. You still can turn on or off outlets during the pulsingperiod though outlet LEDs do not change their status.4. Press to show the following data: Information of total active power (W) and total active energy (Wh). Status of the 12V power supply to the controller. For details onthe sensors, seePDU (on page 176).
