Chapter 6: Using the Web Interface254SHX Request Maximum CoolingThe PX3TS allows you to remotely activate the Schroff SHX 30'smaximum cooling feature. Both LHX 20 and LHX 40 do not supportremote activation of maximum cooling.The Request Maximum Cooling feature is available only after the PX3TSdetects SHX 30. For additional information on the SHX 30 maximumcooling feature, see the SHX 30 documentation.To perform maximum cooling: Go to the SHX page, and click Request Maximum Cooling.Then the SHX 30 enters into emergency cooling mode and runs at itsmaximum cooling level of 100% in order to cool the device.When maximum cooling is requested for an SHX 30, the message"Maximum cooling requested" is displayed.To stop maximum cooling: Click Cancel Maximum Cooling.Power CIMAfter connecting and detecting a Raritan power CIM, the PX3TS shows'Power CIM' in place of 'Feature Port' in the menu. SeeDominion KX II /III Configuration (on page 792) orDominion KSX II, SX or SX IIConfiguration (on page 797).Open the Power CIM page by clicking it in theMenu (on page 146). Thispage shows the CIM's status, including: Number of the FEATURE port where this CIM is connected Its device type Its connection statusFor the functionality of this icon on the top-right corner, seeFeaturePort (on page 237).
